Vehicle Signage
Vehicle wraps and signage for single vehicles and full fleets across Victoria, full and partial wraps, decals and magnetic signage, in cast vinyl with colour-matched graphics.
About This Service
A vehicle wrap works harder than almost any other signage, it's not seen once outside a shopfront, it's seen everywhere the vehicle goes, parked, driving, at every set of lights. That's the appeal, and it's also why a bad install is worse than no wrap at all, a bubble, a lifting edge or a colour that doesn't quite match the rest of the fleet is on public display constantly, not tucked away.
Peak Install applies full and partial vehicle wraps, decals and magnetic signage across single vehicles and full fleets. We use cast vinyl, the material that actually conforms to a vehicle's curves and panel lines without lifting, and colour-matched graphics where a wrap needs to sit alongside a fleet's existing paint code. When a vehicle's being sold, leased back, or rebranded, we handle wrap removal and restoration as well, not just the install.
On a fleet job, the standard isn't one good-looking van, it's every van looking identical to the next. That consistency is the actual difference between a fleet that reads as one brand and one that reads as several different jobs done at different times.
Key Features:
- Full and partial wraps
- Fleet rollouts
- Cast vinyl materials
- Colour-matched graphics
- Removal and restoration
How Peak Install Can Help
Application is where a wrap succeeds or fails. Cast vinyl is applied under heat and pressure to conform to compound curves, mirrors, door handles and panel gaps, and it's applied smoothly, without bubbles, lifting edges or visible seams, that's the difference between a wrap that still looks new in three years and one that's peeling within months.
On a fleet rollout, every vehicle is checked against the same design and colour reference before it goes out, so vehicle twelve matches vehicle one, not an approximation of it. That matters more on a fleet than almost anywhere else in signage, since the vehicles are usually seen side by side, at a depot or on a job site, not one at a time.
When it's time to remove a wrap, whether that's a lease return, a sale, or simply a rebrand, we take the vinyl off without damaging the paint underneath it, restoring the vehicle to a clean, sellable finish rather than leaving adhesive residue or panel damage behind.
Expert Application
Cast vinyl applied smoothly to every curve and panel, without bubbles or lifting edges.
Colour-Matched Graphics
Matched to your fleet's paint code for consistent branding across every vehicle.
Fleet Services
We can handle installations for entire fleets, ensuring consistent branding across all vehicles.
Ready to book your next install?
Get in touch with Victoria's trusted signage installation specialists.
